 |
| Cut out a circle for the base... |
 |
| Extrude some coils... |
 |
| Punch an air hole and put a name stamp on the bottom... |
 |
| Secure the bottom coils well... |
 |
| Build up the bases, connecting each coil... |
 |
| Extrude out some branches, they must have time to firm up... |
 |
| Use small slabs to build up the trunks... |
 |
| Rough them up and then smooth them... |
 |
| Cut out some tiny flowers, and then smooth the sides... |
 |
| Roll the fronts, and then divide the petals... |
 |
| Cut out some nichrome wire... |
 |
| Add flower centers and the nichrome wire... |
 |
| Make some leaves using a sprig mold... |
 |
| Add nichrome wire, once they've been cleaned up... |
 |
| Everything is ready... |
 |
| Beef up the branches... |
 |
| Slip and score the branches... |
 |
| Add the foliage... |
 |
| Here are the branches for the second arbol... |
 |
| Smooth clay near the attachment points... |
 |
| Add foliage... |
 |
| Dry very slowly to avoid cracking... |
 |
| The second finished piece... |
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.